The brand-new PN400 Phase Noise Test System is available for purchase! →

SCPI support to zero span mode

Forums › General Discussions › SCPI support to zero span mode

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 2, 2018 at 5:27 pm #161120
    bittware
    Participant

    Hi
    Could you make SCPI support available to zero span mode?
    Specifically, our application relys on reading the peak auto tracking on the spectrum plot in zero span mode.
    If SCPI implementation won’t be a feasible option, what would be the alternative?
    Thanks.

    • This topic was modified 7 years, 11 months ago by bittware.
    • This topic was modified 7 years, 11 months ago by bittware.
    November 5, 2018 at 8:51 am #161126
    AndrewAndrew
    Moderator

    Hi Bittware,

    I don’t have a timeframe for when SCPI support for zero-span would occur. I’m assuming triggering is an important aspect of your measurement? If so, then using the API directly to request IQ, trigger, and then FFT the IQ data to create the spectrum plot is the only alternative. Otherwise if you do not need triggering, then using SCPI with standard sweep mode seems like it would be adequate.

    If you haven’t seen the APIs yet, you can find them on the SDK landing page.
    https://solutionspagedemo.kinsta.cloud/software/signal-hound-software-development-kit-sdk/

    Regards,
    Andrew

    • This reply was modified 7 years, 11 months ago by AndrewAndrew.
  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.