Reply To: Scalar Network Analysis for Low Frequency with TG124A

[Justin Crooks]

Devjack,
We are looking into this. It does look like we clamp to 1 kHz in this mode, which I can see does not make sense for your measurement, especially since the TG itself has 10 Hz resolution.
Two potential workarounds while we investigate:
1) You can use linear interpolation to get a good estimate of the 3 dB points
2) You can exit scalar analysis mode, and just do a sweep with max hold. Then step the TG in finer steps using the TG control.
I apologize for the inconvenience.

• This reply was modified 12 months ago by Justin Crooks.