The brand-new PN400 Phase Noise Test System is available for purchase! →

BB60C Calibration Files

Forums › SA Series Discussions › BB60C Calibration Files

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 6, 2022 at 9:43 pm #241415
    tlbui
    Participant

    Dear Andrew,

    We try to use a third party software to connect to our BB60C analyzers. The 3rd party software requires the BB60C calibration files “.tep” and “.bin” files to run.

    Could you please send us the calibration files for our BB60C; the serial numbers are:
    21313056 and
    18353744.

    Thank you in advance for your support.

    Regards,
    Tuong Lam

    June 7, 2022 at 8:34 am #241417
    AndrewAndrew
    Moderator

    Tuong,

    The .tep and .bin files are specifically for the SA44/SA124 series devices, not the BB60. The BB60C does not place the calibration files on the PC at any point, and as a result the 3rd party software should not need any calibration files. I would contact the 3rd party software developer and ask them about this.

    Andrew

    June 8, 2022 at 2:35 am #241422
    tlbui
    Participant

    Thank you Andrew.

    Looking for further update from you, if any.

    Best regards,
    Tuong Lam

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.