The brand-new PN400 Phase Noise Test System is available for purchase! →

Dr Dom

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • March 18, 2016 at 5:57 am in reply to: Power Measurement Error of SA124B #85856
    Dr Dom
    Participant

    I tested my unit in a similar way to what Justin has described, I used a swept source and put the SA124B on max hold and let it build up a picture. If it is cracked/open circuit input pin you will see an increasing signal level with frequency. Foltronics in Holland did a great job quickly fixing my unit and it is already back with me – thanks guys! 🙂

    March 15, 2016 at 1:58 am in reply to: Power Measurement Error of SA124B #85536
    Dr Dom
    Participant

    Sounds like a problem I just had, which I think is down to the input connector centre pin. I applied a bit of sideways pressure and the signal shot off. Sent it off to my local retailer for repair last week and waiting for some feedback.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)