The brand-new PN400 Phase Noise Test System is available for purchase! →

hcglitte

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 14, 2016 at 1:51 pm in reply to: Best accuracy settings for CW power measurement #117017
    hcglitte
    Participant

    Sorry, the remaining settings:
    Video units: Power
    Detector: Average

    November 18, 2015 at 1:30 am in reply to: Can't Lower RBW/VBW with some spans #69621
    hcglitte
    Participant

    Hi,

    Wouldn’t it be a possible solution if the SW could set the necessary settings to the SA, then perform a 200 kHz sweep, and then just set the new settings for the next 200kHz sweep – but still keeping the display window results for the previous 200kHz sweeps? When the frequency gets beyond 16Mhz just one setting would need to be sent to the device for the rest of the sweep.

    This way the hard limitation of the device would be transparent to the user.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)