The brand-new PN400 Phase Noise Test System is available for purchase! →

Nathan Snyder

Forum Replies Created

Viewing 1 post (of 1 total)
  • Author
    Posts
  • December 9, 2024 at 8:17 am in reply to: LabVIEW Device not open #246535
    Nathan SnyderNathan Snyder
    Moderator

    If you are using the LabVIEW bindings, and an error is returned, say because Spike was opened, then most likely LabVIEW will need to be restarted and the device power-cycled. Otherwise resources may not be cleaned up properly within the LabVIEW environment, causing errors when trying to connect to the device again.

  • Author
    Posts
Viewing 1 post (of 1 total)